Milweld Auto Arc XLT 165, XLT 135 Spécifications télécharger pdf (Page 30)

OM-218 696 Page 26

5-7. Replacing Switch And/Or Head Tube

Ref. 800 795-C

1 Remove handle

locking nut.

2 Remove switch housing. Note: If installing new

switch, push switch lead connectors onto terminal of

new switch (polarity is not important). Install switch

back into handle, and secure with handle locking nut.

If replacing head tube, continue to end of figure.

3 Slide handle.

4 Secure head

tube in vice.

5 Loosen jam nut. Remove

from vice and turn head

tube out by hand.

6 Install existing shock washer onto

new head tube. Hand-tighten head

tube into connector cable.

7 Place head tube in vice and tighten

until nuts are tight.

8 Remove from vice. Reposition

handle and install switch housing.

Secure with handle locking nut.

Y Disconnect gun first.

3/4 in

Tools Needed:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

Pas de commentaire

Milweld Auto Arc XLT 165, XLT 135 Spécifications Page 30