Milweld MW 140 Plus Spécifications télécharger pdf (Page 29)

OM-219 316 Page 25

7-7. Replacing Switch And/Or Head Tube

Ref. ST-800 795-C

Tools Needed:

19 mm

Remove handle

locking nut.

Slide handle.

Secure head

tube in vice.

Loosen jam nut.

Remove from vice

and turn head tube

out by hand.

Hand-tighten head tube into cable connector.

Place head tube in vice and tighten until

nuts are tight.

Remove from vice. Reposition handle and install

switch housing. Secure with handle locking nut.

Y Turn Off welding power source

/wire feeder and disconnect gun.

Remove switch housing. Install new switch and

connect leads (polarity is not important).

Reassemble in reverse order. If replacing head

tube, continue to end of figure.

1

3

2

4

5

8

6

7

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Commentaires sur ces manuels

Pas de commentaire